Eibach Shop
Clients about us

Eibach Pro Spacers 25/50mm: Nissan 6x114,3mm

Ask for price148,83€ tax incl.
121,00€ tax excl.

Why do I have to pay tax?

Product code:
CLICK here to check product availability
Track widening per axle:
Number of Holes:
Bolt Hole Circle Ø:
Centering Diameter:
Pieces in set:
2 spacers


Product description

Set of Pro-Spacer for front or rear axle 25/50mm suitable into:

  • Nissan Navara Platform/Chassis (D23), NP300 Navara (D40), NP300 Navara Pickup (D23), NP300 Navara Platform/Chassis (D40), Pathfinder III (R51)


  • When using the wheelspacers you have to verify that the wheels being used have suitable cut-outs to take up the original bolts. Without these cut-outs it is not possible to use the wheels or wheelspacers! Please check as follows: Stud lengh (e.g. 25mm) minus spacer-thickness (e.g.15mm) = 10mm exess length. So the cut out should have 11mm depth to take the original stud. Further the cut out should have minimum 22mmx22mm height/width to take the overlaping nut. ATTENTION: when using 15 mm spacers at least 7 mm deep cut-outs are needed as the nuts stand over the contact surface!

Global informations

You have to consider the requirements of the Components Certificate. Components Certificate-requirements are available at www.eibach.com

Our wheelspacers are produced in consideration of the original wheels. When using acessory- or specialwheels, you have to check, if these wheels comply with the necessary requirements. Expecially on cars with studs/nuts. Further we point out, that the larger the wheelsize is, the sensitively reacts the steering in relation to vibrations. (Often caused by badly balanced wheels.) In any case of reconstruction (even with OE-accessory-parts), as the installation of an accessory-brake-system (e.g. ceramic-brakes), sport-suspension, LPG-(liquefied petroleum gas)-system for example, the usage of our products may be excluded.

§ 21-acceptance - In Germany and other European states it is necessary to approve wheelspacers by a Components Certificate-organisation. If this is necessary in your country, please contact your nearest test center to get more information about requirements and costs.

Wheelspacers always should be mounted by hand. - Don´t use electric or pneumatic tools as this could cause vibrations because of misfit on the wheelhub.

From March 2011 the use of steel wheels in combination with Pro-Spacer-wheelspacers is prohibited if not especially allowed by the Components Certificate.

Existing center- and assembling-aids at the wheel hub have to be removed. (e.g. fixing bolts, clamps or rings of the brake disk or -drum)

Additional information

Any questions about this product?
Call us: (+48) 56 652 12 12 or send us email.

Ask for details

Name and surname:


Phone number:

Your question:

Enter code from the picture: